Quadrantal angles and undefined values — quick review
Picture a clock hand stopping exactly at the top, bottom, left or right.
sin θ = y and cos θ = x at the axis points with r = 1.
tan θ and sec θ are undefined at θ = 90° + n·180°; cot θ and csc θ are undefined at θ = n·180°, where n is any integer (positive, negative or zero). In radians these are + nπ and nπ.
If this is a quadrantal angle, add or subtract full turns until 0° ≤ θ < 360°; in radians use turns of 2π.
Match its terminal side to (1, 0), (0, 1), (−1, 0) or (0, −1).
Read sin θ = y and cos θ = x.
Write tan = , cot = , sec = and csc = .
Inspect every denominator first. A zero denominator gives undefined; otherwise do the division.
Find all six functions at −540° and −450°. In words, remove complete turns, find the axis point, then read the six ratios.
At −540°:
sin = 0
cos = −1
tan = 0
cot = undefined
sec = −1
csc = undefined
At −450°:
sin = −1
cos = 0
tan = undefined
cot = 0
sec = undefined
csc = −1
Writing 0 when the answer is undefined, or the reverse. = 0 is a real value; has no value. Look at which coordinate sits on the bottom before you answer.
If this is a quadrantal angle, add or subtract full turns until 0° ≤ θ < 360°; in radians use turns of 2π.
Match its terminal side to (1, 0), (0, 1), (−1, 0) or (0, −1).
Read sin θ = y and cos θ = x.
Write tan = , cot = , sec = and csc = .
Inspect every denominator first. A zero denominator gives undefined; otherwise do the division.
Terminal side
The ray where an angle ends after its rotation. The point definition reads a point on it.
Quadrantal angle
An angle whose terminal side lies on an axis: 0°, 90°, 180°, 270°, 360°, and angles coterminal with them.
Undefined
No value exists, because the formula would divide by zero.
Domain
All the inputs a function accepts. sin and cos accept every angle; tan and sec skip angles on the y-axis; cot and csc skip angles on the x-axis.
Radian
An angle unit: one radian cuts off an arc exactly as long as the radius. π radians = 180°.
Origin
The coordinate address (0, 0), where the two axes cross.
Coterminal angles
Angles that end on the same ray after rotations differing by whole turns.
Function
A rule giving exactly one output for each allowed input. Trigonometric functions take angle inputs and produce numerical ratios.
Ratio
A comparison of one quantity with another by division. The order says which quantity is on top.